My Mill Convection heater does not generate any heat. What do I do?

All Mill Convection heaters (with exception of SG2000MEC and CO2200MECMAX) have a lightning symbol on the heater’s display indicating if the heater is generating heat or not. If the lightning symbol is on the heater should be generating heat.

If the heater does not generate heat when the lightning symbol is on, it is likely there is a problem with your Mill Convection Heater. To troubleshoot if the heater is defect or not, please do the following:

1. Reset the heater
2. Set the heater to maximum temperature (35 degrees Celsius).
3. Please note: SG2000MEC / CO2200MECMAX cannot be reset, to check if these heaters are working you can only set the heater to MAX
4. Within a couple of minutes your heater should be warm. You can check this by holding you hand over the top of the heater.

If the heater does not become warm contact the store where you purchased your heater to receive further help (please remember to bring your receipt).

If the heater does heat and everything seems to be in order after doing this procedure, you need to calibrate the heater so it adjusts to the room it is located in.